Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

10.06.2025 08:02

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

nine

Are you struggling with weight loss and finding it hard to stay consistent? What’s your biggest challenge when trying to lose weight at home?

2024–10–16 [ OO OLAOYE OYEBODE ]

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

Exercise improves colon cancer survival, high-quality trial finds - Ars Technica

These devices are installed between the “hot” and “neutral” and protective ground.

It also is a device that limits the change in current flow.

There are three different concepts here that are getting confused.

What's next for the video game industry as Nintendo launches the long-awaited Switch 2 - NPR

This is where the MOV conducts again, and dissipated the energy.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

Now when you have a certain ac resistance, then a current flows in a loop.

The European Central Bank is almost guaranteed to cut rates. Here's what could happen next - CNBC

One is “what exactly is in a ‘surge protector’ ? ”

what exactly is a ‘surge’ protector?

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Is it possible for a judge to hold someone in contempt for not being able to pay a fine that was imposed during their sentencing hearing?

but I think this circuit , shows a few more pieces.

At one ohm, the resistor has a maximum of 1 watt power.

the problem then depends on "how fast does the fuse operate?".

Scientists Stunned as Rare Phenomenon Emerges from Arctic’s Icy Depths - Indian Defence Review

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

This device then solves the entire problem.

Because the load is inductive, the current lags the voltage.(by a bit).

James Webb Detects Never-Before-Seen Molecule on Scorching Exoplanet - The Daily Galaxy

[image of Common-mode choke]

(Dc diagram shown, AC is similar).

These are simplified answers to the original question, and does not change anything I wrote above.

Trump threatens ‘very serious consequences’ if Musk backs Democrats - The Washington Post

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

Is modular building a fix for NY's housing crisis? State officials hope so. - Gothamist

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

2024–10–10[John johnson John Johnson ]

Why do women need to wear bras, in spite of the fact that the breasts are an integral part of the body?

a photo is worth a thousand words.

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

Here is a simplified AC power diagram.

Even Captain James T. Kirk was trapped in a woman's body. Don't you think he'd support trans people?

This is where this question deviates from being a 'generic' question, and becomes more specific.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

A circuit breaker is similar, but is resettable.

As a woman, what would be you response to a male friend’s offer of a full body massage?

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

First Sentence:

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

Wall Street warns Trump aides the GOP tax bill could jolt bond markets - The Washington Post

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

He then describes Rainy Season and Lightning.

He then describes the function of a fuse.

Why do men like to have sex with a woman's ass?

An AC voltage/ current source, and an ac inductive load.

He then asserts :

This one hit behind the barn.

Single-dose CAR-T therapy potentially curative in multiple myeloma - Medical Xpress

Barnstars:

This is 'the assistant's answer'

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

But it can get overloaded, and no longer works.

But… the neutral is now “floating” because of the 1 ohm resistance.

In schematic diagrams this is the symbol for a fuse:

so, what happens?

The bolt then partially travels down the line to your home.

It seems Mohan does not understand the difference between a comment and an Answer.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

but this device (an Inductor) … impedes the rapid changes in the current.

eight

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

There are two important concepts here.

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

I post the exact comment here.

For this case there are devices called Metal oxide varistors (MOV).

The MOV will conduct when the voltage exceeds 50% of line voltage.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

What does a fuse do?

A fuse is a non-resetable over current circuit protector.

2024–10–14 [Omar Gharbi Omar Gharbi ]

What is lightning?

This is the picture of an electronic coil of wire wound around a core of magnetic material.

Upvotes:

Edit 2024–10.

The third is lightning and “how it gets conducted into a home.”

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

The other is “what does a “fuse” do?”

[old diagram got deleted by accident]

So, the voltage could go up to 500 volts, and the fuse will not open up.

One

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

Can the fuse protect the electronic devices from lightning instead of a surge protector.

At least they know the answer if they wanted it.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.